G400E
User Manual
OpenVox Communication Co. LTD.
URL: www.openvox.cn
14
Chapter 3 Software Installation and Configuration
3.1 Hardware detection
Detect hardware by executing command:
# lspci –vvvv
Check the outcome and confirm your system has recognized G400E. If it
has been recognized, the output information will be showed like that:
01:04.0 Class ff00: Unknown device 1b74:0100 (rev 01)
Subsystem: Unknown device 1b74:0104
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 66
Region 0: Memory at dedf0000 (32-bit, non-prefetchable)
[size=64K]
Figure 6 Hardware detection
If G400E is not recognized by the system, you have to power off and take
out of the card, then try to insert it into another PCI-E slot.
3.2 Dependencies installation
Some dependencies are crucial, if any of them is absent, the software
installation process would not go through successfully. Let’s run
"
yum
install XX
"
(XX stands for the dependency’s name) to check the
