Opengear ACM5000, Руководство пользователя

Страница: 150 / 335

Chapter 7: Alerts and Logging
150
Console Server & RIM Gateway User Manual
ALERTS, AUTOMATED RESPONSE AND LOGGING
This chapter describes the automated response, alert generation and logging features of the console server .
The new Auto-Response facility (in firmware V3.5.1 and later) extends on the basic Alert facility available in earlier
firmware revisions. With the new facility the
console server monitors selected serial ports, logins, the power status and
environmental monitors and probes for Check Condition triggers. The console server will then initiate a sequence of
actions in response to the triggers. To configure you:

set general parameters ( Section 7.1 ), then

select and configure the Check Conditions i.e. the conditions that will trigger the response ( Section 7.2 ) , then

specify the Trigger Actions i.e. sequence of actions initiated in the event of the trigger condition (Section 7.3), then

specify the Resolve Actions i.e. actions performed when trigger conditions have been resolved (Section 7.4)
All console server models can maintain log records of all access and communications with the console server and with the
attached serial devices. A log of all system activity is also maintained as is a history of the status of any attached
environmental monitors.
Some models also log access and communications with network attached hosts and maintain a history of the UPS and
PDU power status.

If port logs are to be maintained on a remote server, then the access path to this location need to be configured
Then you need to activate and set the desired levels of logging for each
serial and/or network port (Section 7.6)
and/or power and environment UPS (refer Chapter 8 )
7.1 Configure Auto-Response
With the Auto-Response facility, a sequence of Trigger Actions is initiated in the event of a specified trigger condition
(Check Condition) . Subsequent Resolve Actions can also be performed when the trigger condition has been resolved.
To configure, first set the general parameters that will be applied to all Auto-Responses:

Check Log Events on Alerts & Logging: Auto-Response to enable logging all Auto-Response activities

Check Delay after Boot to set any general delay to be applied after console server system boot, before
processing events