Quick Start Guide
700-0163-200
Key Features
Additional Information
Ne
ed H
elp?
Step 3
Mount Your Sensor
Status indicator light
Pairing button
Magnet tab
Tamper sensor
Mounting plate
Quick release button
3/4” maximum
Top view
1
6
2
3
4
8
7
5
9
D
D
E
E
F
F
G
G
A
A
A
B
F
E
D
G
A
B
Using the included adhesive pads or screws, mount
one piece of the sensor onto the moving part of your
door or window, and then mount the other onto your
door or window frame. These pieces should be
mounted so that when the door or window is closed
the dots are no more than 3/4 inch apart.
Starting pairing mode
Your sensor automatically enters pairing mode when
you insert the batteries. You can also press and hold
the pairing button for five seconds to start pairing mode.
Status indicator light blinks quickly when in this mode.
Checking battery level
Tap the pairing button to check the battery level.
A long flash indicates that the battery is good.
A slow blink indicates that the battery is low.
To get the best perfromance from your sensor, mount the
two pieces of the sensor such that they separate either
vertically or horizontally when the door or window opens.
If they separate laterally, the sensor may not
function properly.
Support articles
www.ooma.com/support
User manuals
www.ooma.com/userguide
Community forum
forums.ooma.com
Live customer care
1-888-711-6662 (US)
1-866-929-5552 (Canada)
Legal
For warranty, safety, and other legal information,
visit
ooma.com/legal
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
Status indicator reference
Pairing mode
Quick red flashes
Battery good
Long red flash
Battery low
Short red flashes
Software update
Slow red double flashes
Keep the front side of both pieces
even with each other if possible.
If needed, attach additional
risers (included) to raise the
height of the magnet tab.
Step 1
Install the App
Step 2
Pair Your Sensor
To get started, download and install the
Ooma Home
Security
app on your iOS or Android device.
The app can be found at:
ooma.com/app
When the app is installed, log in using your Ooma
phone number and My Ooma password. If you forgot
your password, reset it at:
my.ooma.com
Complete the initial setup in the app.
Step 1
Install the App
Step 2
Pair Your Sensor
For the best pairing performance, hold your sensor within
10 feet of your Telo.
In the mobile app, press the “
Add Sensor
” button on the
Dashboard. Select the type of sensor you would like to pair.
Follow the instructions on your screen to pair your sensor.
If you are using the included adhesive pads to mount
your sensor, use a damp cloth to wipe the surface
where you are placing your sensor.
door & window sensor
10 feet
