ONLINE ELECTRONICS LTD
3015_5001_A01
Page 7 of 17
3.
RULES FOR SAFE OPERATION
⚠
WARNING: The Special Conditions for Safe Use as detailed in Section 8 APPENDIX A –
ATEX SPECIFIC INSTRUCTIONS must be followed at all times.
⚠
WARNING: Any operation involving pressure is potentially hazardous. No person should
use this equipment unless fully aware of the potential hazards of working with pressurised
vessels. The purchaser of this equipment is responsible for the training and competence of
operators and the manner in which it is used. This manual should be read through and
understood before installation and commissioning so that the operator is familiar with the
equipment. Contact Online Electronics Ltd immediately should any difficulty arise in the use of
this equipment.
⚠
WARNING: DO NOT open when an explosive atmosphere may be present. Always use
caution when opening equipment which has been in a pressurised environment. It is possible
for pressure to leak into the equipment and remain there even after external pressure has
been removed. ALWAYS point the end to be opened towards a safe area and away from
yourself or others. Contact Online Electronic immediately if there is a suspicion that the
equipment has become pressurised.
⚠
WARNING: Only DURACELL INDUSTRIAL ID1300 ALKALINE cells are permitted to be used
in this equipment.
⚠
WARNING: Replace all batteries at the same time. NEVER install used batteries. NEVER
install a mix of new and used batteries. USE ONLY new batteries from the same package or
manufacturing batch. DO NOT mix different brands or types of batteries. ALWAYS observe
correct battery polarity. New batteries should be installed before each deployment.
⚠
WARNING: Do not expose to aggressive solvents or chemicals which could be harmful to
the HOUSING, O-RINGS, CONNECTORS or any other parts of the equipment.
⚠
CAUTION: Opening of the equipment should take place in a clean laboratory environment.
⚠
CAUTION: To prevent the formation of condensation within the transmitter, allow the
transmitter temperature to stabilise within the laboratory environment for a minimum of 6
hours prior to opening.
⚠
CAUTION: It is possible for liquids to become trapped in threads and/or gaps around
openings. ALWAYS point the end to be opened downwards to allow any trapped liquid to drain
out of and not into the equipment.
⚠
CAUTION: If the transmitter is to be placed in storage, always ensure that it is turned OFF
and the batteries are removed and stored separately.
