68
En
The AV receiver allows you to update the firmware using
a USB device.
Note
• Never unplug or turn off the AV receiver during the update
process.
• Never plug or unplug an HDMI cable or a USB device during the
update process.
• Never unplug the USB storage device containing the firmware
file or the AC power cord during the update process.
• Do not attempt to access the AV receiver from your PC while it
is being updated.
• It takes about 30 minutes to complete the firmware update.
• The AV receiver will retain all your settings after the update is
finished.
Before you start
• Set the “
HDMI Ctrl (RIHD)
” setting to “
Off
”
(
• Turn off the controller device connected via Ethernet
cable.
• Turn off Zone 2.
• Stop playback of contents from Internet Radio,
iPod/iPhone, USB or servers, etc.
• If there is any data in the USB device, remove it first.
Update procedure
Updating the Firmware via USB
1
Connect a USB device to your PC. If there is any
data in the USB device, remove it first.
2
Download the firmware file from the Onkyo web
site. The file name is as follows:
ONKAVR****_************.zip
Unzip the downloaded file. The following three
files are created:
ONKAVR****_************.of1
ONKAVR****_************.of2
ONKAVR****_************.of3
3
Copy the extracted files to the USB device. Be
careful not to copy the zip file.
4
Remove the USB device from your PC and
connect it to the
USB
port on the AV receiver.
5
Make sure the AV receiver and TV are turned on.
If the AV receiver is in standby mode, press
8
ON/STANDBY
on the AV receiver to light the
front display.
6
Select the USB input source.
“
Now Initializing...
” is displayed on the front
display and then the name of the USB device is
displayed. It takes 20 to 30 seconds to recognize the
USB device.
7
Press
RECEIVER
followed by
SETUP
on the
remote controller.
Setup menu will be displayed on the TV screen. The
procedures thereafter can also be performed on the
AV receiver by using its
SETUP
, arrow and
ENTER
buttons.
8
Select “Update” and press
ENTER
.
9
Select “Via USB” and press
ENTER
.
10
Select “Update” and press
ENTER
.
The update process will begin.
During the update process, the on-screen display
may disappear depending on the updated program.
When this occurs, you can still view the update
progress on the front display of the AV receiver. The
on-screen display will reappear after the update is
complete, and upon turning the AV receiver off and
on again.
Do not turn off the AV receiver and do not remove
the USB device during the update process.
11
The message “Completed!” appears on the front
display of the AV receiver, indicating that the
update has been completed.
Remove the USB device.
12
Turn off the AV receiver using
8
ON/STANDBY
on the front panel.
Do not use
8
RECEIVER
on the remote controller.
Once turned off, the AV receiver will automatically
turn on again.
Congratulations! You now have the latest firmware
installed on your Onkyo AV receiver.
Содержание HT-R648
Страница 75: ...75 En Memo...
