OneRemote 30017742, Руководство пользователя

Страница: 12 / 14

www.oneremote.dk
12
OPTION PROGRAMMING
The PowerLink Switch may be programmed with different options, determining the way the
switching is done. Programming is made only once, during the initial installation.
Programming an option is easy. Programming is carried out using the Bang & Olufsen remote
control. During programming an IR-receiver needs to be connected to the switch.
1. Press and hold the programming switch on the PowerLink Switch, until the Status LED
turns red.
2. Press a 2 key option code from the tables below on your Bang & Olufsen remote control
within 30 seconds. The Status LED is acknowledging the input by turning green.
Status LED During Option Programming
Red The programming switch
has been activated for more
than two seconds, and the
PowerLink Switch is in the
option programming mode.
When in the programming
mode the 2 key option code
must be entered within 30
seconds.
Flashing
Green An option has been entered
correctly.
Flashing
Red An error occurred while
entering an option.
No changes have been
made.
Green Idle, more than 30 seconds
passed without receiving
data.
2-Key Switching Mode Option Table
q0
Sound source selection is
controlled only via an
external IR-receiver.
Any source key may be
used to select one of the
two sources. Refer to the
IR-source option table
below for these options.
q1
When one of the two
sources is powered on,
the switch directs this
sound signal to the
speakers.
q2
If the source connected
to input 2 is powered on,
the switch directs the
sound signal from it to
the speakers, otherwise
the sound signal from
input 1 is selected.