6
Mini-Gorilla Owner’s Manual O.A.S. 2010
c
Assembly Instructions for Wall Bracket
1. Before you attach the wall bracket to the wall, you must
determine the proper height the collector has to be hung at.
This height will be determined by the height of the dust drum
you are using.
2. There are two ways to attach your collector to a stud-
ded wall. You can either attach a sturdy board between two
studs and then attach the wall bracket to the board or using
the center slots, attach the wall bracket to a single stud in
the wall. Use the appropriate hardware to hold the bracket
to the wall. The collector and wall bracket are heavy. Make
sure the bracket is level when it is attached.
3. The collector can only be attached to the wall bracket
with the cyclone inlet in front as shown in picture. Line up
the holes in the cyclone support ring with the slots in the top
of the wall bracket and use the provided bolts, two washers
and nut to attach the collector to the bracket through the
three slots in the bracket.
*Note: A spacer may be needed between the bracket and
the support wall so the flex hose from the bottom of the
cyclone lines up with the dust drum opening.
12.5”
12”
10”
13.5”
12”
12.5”
Top
Front
Side
VI. General Assembly Instructions
35 / 55 Gal.
23” (35 Gal.)
35” (55 Gal.)
30” (35 Gal.)
42” (55 Gal.)
Minimum to bottom
edge of Bracket
2.5”
Spacers
If Desired
Optional 17 Gal. Drum will
fit tight against the wall.
Shown with
35 Gal. Drum.
