Ref: RD-HGHGW050300-EN-02
6
UDgateway - Hardware Guide
UDgateway Overview
Hardware model : H3
2.2.
The UDgateway® High-End appliance is intended for installation in 19-inch telco
racks.
Characteristics:
- Standard 19 inch rack mounting, 1U height
- Cover and housing: metal
Compared to H2 hardware model, UDgateway H3 hardware model:
- has an additional Ethernet bypass board
- is sized to support CPS40 and CSP60 software packages.
Note
: Thanks to Ethernet bypass board, a power-off of an UDgateway configured
in bridge mode will behave as a straight Ethernet cable passing traffic from one
side to the other (from fxp0 to xl0 and vice-versa).
Front Panel
2.2.1.
A number of elements are situated on the front panel of the UDgateway that enable
you to check that the UDgateway is correctly connected.
5
6
2
4
3
1
UDgateway - H3 hardware - Front Panel
Figure 3 -
1
Power On/Standby button and system power LED
Green = system is on
Amber = System is shut down, but power is still applied
Off = Power cord is not attached, power supply failure has occurred, no power
supplies are installed, facility power is not available, or the DC-to-DC converter is
not installed.
2
UID button/LED
Blue = Identification is activated
Flashing blue = System is being remotely managed
Off = Identification is deactivated.
3
Internal health LED
Green = System health is normal
Amber = System is degraded. To identify the component in a degraded state,
refer to system board LEDs.
Red = System critical. To identify the component in a critical state, refer to system
board LEDs
Off = System health is normal (when in standby mode).
