1645
Chapter 2
User manual
Installing and connecting the 1645
17
2.4
Mounting the 1645 on a wall
Procedure
The bottom plate of the 1645 has 2 notches in order to enable wall mounting. Refer to the figure below,
for the position of these notches. By installing two screws at the required distance, the device can be
hung on any vertical surface.
In order to do so, proceed as follows:
Step
Action
1
Drill two holes in the wall, according to the following specifications:
• hole diameter: 5 mm
• distance between the holes: 160 mm
• hole depth: at least 50 mm
2
Insert two standard wall plugs in the holes. The plugs should have the following dimen-
sions:
• diameter: 5 mm
• length: < 50 mm
3
Screw in two standard screws in the plugs. Leave a distance of 5 mm between the wall
and the head of the screw. The screws should have the following dimensions:
• diameter: 3 mm
• length: 30 mm
• The head of the screws may have a diameter of maximum 8 mm.
4
Slide the 1645 over the screws until it touches the wall, and gently push it down. If nec-
essary, adjust the screws in the notches of the device.
