Once AgriShift LCL-0.2-120V, Инструкция по установке и эксплуатации

Страница: 10 / 40

AgriShift
®
Lighting Control Unit MASTER - Model LCL-0.2
8
SEC
TIO
N 2
2.7 STARTING THE SYSTEM
Before using the controller for production purposes, it is essential to observe
the following configuration steps (see relevant sections below for details):
System configuration is the first step in starting a new system. Ensure the
system has been connected and power supply is turned on to the unit per
section 2.6.
SYSTEM SETUP
1. Review section 3.1 to become familiar with the front panel, the
programming modes and the navigation/control screens.
2. From the Home Screen, go to the Configuration Menu and select
Outputs. Enable outputs. You can now calibrate lighting intensity as a
function of applied voltage or wait until a later time to do so. See
Configuration-Outputs menu (section 5.1).
3. For safety reasons, all newly configured outputs are automatically set
to MANUAL mode. Switch all outputs from MANUAL to AUTO-
MATIC mode. (See section 4.6 Output Control.)
4. Place the front panel control switches in Manual Mode (ON position
per 3.1.4) and verify the LED lights operate and dim properly.
OPERATING SETUP
5. Using the navigation buttons and the LCD screen, select Configuration
then Local Settings. Set the date and time of the system (24 hour mode
recommended) to allow a consistent functioning of the lighting periods.
Then set your display preferences.
(See Menu Configuration-Local Settings menu (section 5.3.)).
6. Select Lighting from the Main Menu then select Curve. Configure
lighting curves to determine the lighting periods throughout the
production cycle. (Refer to section 4 – Operating Parameters.)
7. Return to the Configuration menu and select Advanced Parameters.
Verify these are set properly to your particular situation. (section 5.2)