Evolution 05 Recessed Camera
QUICK START GUIDE
Important
•
Read these instructions carefully before installing
or operating this camera.
•
This camera should be installed by a qualified
service person and the installation should
conform to local and national regulations.
•
This camera conforms to UL2043, which certifies
it as suitable for installation in a wall or ceiling
used also as an air handling space.
•
Certified as FCC Class A. In a domestic
environment this camera may cause radio
interference in which case the user should take
adequate measures.
DANGER: RISK OF EXPLOSION IF
REPLACING A BATTERY WITH AN
INCORRECT BATTERY TYPE.
Welcome
The Oncam Evolution 05 Recessed 360° camera is
designed to be connected to an IP network. Configure
and operate the camera using a standard internet
browser.
Described are the installation and configuration
procedures for a standard surface mount camera
application.
Power Input
12 VDC, 1.0 A (min) LPS, NEC Class 2
power supply or Power over Ethernet (PoE),
IEEE standard 802.3af
Operating
Temperature
0 to +40°C (-32 to +104°F)
Housing Material
Aluminium with polymer trim cover
Weight
0.74 kg (1.63 lbs)
MAC Address
Document the camera’s installation location and unique
MAC address. Find the MAC address printed on the
camera label. This information may be needed during
camera configuration.
Mounting & Installation
The Evolution 05 Indoor Recessed camera is a
recessed mounting for drop ceilings or walls with a
maximum cross section of 25.4 mm (1-inch).
1. Remove the camera cover.
2. Detach the cover retaining strap from the casing by
removing the retaining nut.
3. Remove the camera by loosening the thumb screw.
4. Remove the cable entry cover.
Cable side and top options are
available.
5. Cut a 152 mm (6-inch) hole in the
mounting location. A template is
supplied.
6. Pass the network cable through the cable entry
hole in the casing.
7. Adjust the casing and
insert the casing into
the pre-made hole.
8. Secure the casing
by tightening the two
screws engaging the
two retention fins.
Recessed View
9. Connect the network cable to the camera and
reinsert the camera into the casing. Fasten the
thumb screw firmly.
10. Reattach the cover retaining strap with the retaining
nut.
11. Aligning the magnets, place the cover on the
casing.
12. Remove the lens protector.
13. Ensure the LED lights illuminate.
EVO-05-NRD
Supplied Parts
• EVO-05 Camera
• Quick Start Guide
• Back Box
• Drilling Template
• Trim Cover
Technical Support
For the A&E, Specification, Installation and User Manual, Software
and Firmware visit:
https://www.oncamgrandeye.com/resources/product-downloads/
Tel:
UK +44 (0)20 7371 6640
US +1 978 735 4860
Email:
