Evolution 05 Mini Outdoor
QUICK START GUIDE
Welcome
The Oncam Evolution Mini Outdoor 360° camera is
designed to be connected to an IP network. Configure
and operate the camera using a standard internet
browser.
Described are the installation and configuration
procedures for a standard surface mount camera
application.
Power Input
Power over Ethernet (PoE),
IEEE standard 802.3af
Operating
Temperature
-40 to +55°C (-40 to +131°F)
Enclosure
Aluminum with polymer bubble
Weight
0.32 kg (0.70 lbs)
MAC Address
Document the camera’s installation location and unique
MAC address. Find the MAC address printed on the
camera label. This information may be needed during the
camera configuration.
Mounting & Installation
The Evolution Mini Outdoor camera is intended for
mounting on flat surfaces, such as walls or ceilings. The
camera comes fitted with an RJ45 or M12 flying lead for
connectivity to data and PoE.
NOTICE: Do not over-tighten the Torx screws. Only hand
tighten.
1. Using the drilling template, drill holes sized for the
mounting hardware and network connector pigtail.
2. Loosen the screws with the Torx screwdriver bit.
3. Carefully remove the trim cover, ensuring the gasket
is not damaged or removed.
4. Secure the camera base to a wall or ceiling with
the appropriate mounting hardware. Pull the cable
through the mounting surface.
5. Realign the front cover to
the base, ensuring the Gore
vent holes are aligned with
the side arrow.
6. Fasten the Torx screws and
install the protective caps.
Important
•
Read these instructions carefully before
installing or operating this camera.
•
This camera should be installed by a qualified
service person and the installation should
conform to local and national regulations.
•
This product is only suitable for a surface
mount installation and should not be modified
or adapted for any type of plenum installation.
•
Certified as FCC Class A. In a domestic
environment this camera may cause radio
interference in which case the user should take
adequate measures.
DANGER: RISK OF EXPLOSION IF
REPLACING A BATTERY WITH AN
INCORRECT BATTERY TYPE.
Supplied Parts
• EVO-05 Mini Camera
• Torx Screwdriver Bit
• Mounting Kit
• Drilling Template
• Quick Start Guide
RJ45
EVO-05-LMD
M12
EVO-05-LMM
Technical Support
For the A&E, Specification, Installation and User Manual, Software
and Firmware visit:
https://www.oncamgrandeye.com/resources/product-downloads/
Tel:
UK +44 (0)20 7371 6640
US +1 978 735 4860
Email:
