Omron ZUV Series, Руководство пользователя

Страница: 71 / 126

4-3
ZUV
User’s Manual
Section 4
CONNECTING TO EXTERNAL DEVICES
Section 4
Connection by an I/O Terminal Block
●
I/O terminal pin assignments
•Terminal block A
•Terminal block B
Indication I/O Signal Name Indication I/O Signal Name
17 RDY1 Output Ready output CH1 25 UVON Output Output during UV
irradiation
18 RDY2 Output Ready output CH2 26 ERROR Output Error output
19 RDY3 Output Ready output CH3 27 COMOUT — Output COM
20 RDY4 Output Ready output CH4 28 NC — No connection
21 TRGOUT1 Output Unused 29 NC — No connection
22 TRGOUT2 Output Unused 30 NC — No connection
23 TRGOUT3 Output Unused 31 +24V — +24V power supply input
24 TRGOUT4 Output Unused 32 GND — 24V input GND
Indication I/O Signal Name Indication I/O Signal Name
1 AIN1 Input 0 to 5V analog input 1 9 TRG4 Input UV irradiation start/stop
input CH4
2 AIN2 Input Unused 10 BANK0 Input Bank switching input 0
3 AIN3 Input Unused 11 BANK1 Input Bank switching input 1
4 AIN4 Input Unused 12 BANK2 Input Bank switching input 2
5 AG — Analog input GND 13 BANK3 Input Bank switching input 3
6 TRG1 Input UV irradiation start/end
input CH1 14 EMGCY Input Input of emergency stop
7 TRG2 Input UV irradiation start/stop
input CH2 15 COMIN — 0V (input COM)
8 TRG3 Input UV irradiation start/stop
input CH3 16 FG — Frame GND
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16 28
17
18
19
20
21
22
23
24
25
26
27
29
30
31
32
Numbers 16, 31, and 32: 1.00 to 1.50 mm
2
Other than the above: 0.10 to 1.50 mm
2
• The stripped cable length is approximately 7 mm.
Wire length: 30 m and less
Pay attention to the following points
regarding the electric wire used for the
terminal block:
• The size of the recommended cross
section is as follows: