Omron V750 series, Руководство по подключению к сети

Страница: 14 / 78

7. Connection Procedure
7. Connection Procedure
This section describes the procedure for connecting the RFID Reader/Writer to the Controller
via Ethernet.
This document explains the procedures for setting the Controller and RFID Reader/Writer
from the factory default setting. For the initialization, refer to
Section 8 Initialization Method
.
7.1. Work Flow
Take the following steps to connect the RFID Reader/Writer to the Controller via Ethernet.
7.2 Setting Up the RFID Reader/Writer
Set up the RFID Reader/Writer.
↓
7.2.1 Parameter Setting Set the parameters of the RFID Reader/Writer.
↓
7.3 Setting Up the Controller
Set up the Controller.
↓
7.3.1 Starting the Sysmac Studio and
Importing the Project File
Start the Sysmac Studio, and import the project file.
↓
7.3.2 Checking the Parameters and
Building
Check the set parameters, execute the program
check on the project data and build the Controller.
↓
7.3.3 Connecting Online and
Transferring the Project Data
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
↓
7.4 Connection Status Check
Execute the program and confirm that Ethernet
communications are normally performed.
↓
7.4.1 Executing the Program and
Checking the Receive Data
Execute the program and confirm that the correct
data are written to the variables of the Controller.
Precautions for Correct Use
Prepare the latest project file in advance.
To obtain the file, contact your OMRON representative.
11