Omron SYSMAC W398-E1-1, Руководство по эксплуатации

Страница: 75 / 127

61
Editing Zone Settings Section 4-8
4-8 Editing Zone Settings
4-8-1 Zone Setting Screen
On the project tree, either double-click Edit Zone, or select it and press the
Enter Key.
Example: The following will be displayed as the 4-axis NC Unit Zone Setting
Editing Screen.
4-8-2 Editing Zone Settings
The zone setting range is as follows.
Pulse: C0000001 to 3FFFFFFF Hex (
±
1,073,741,823) (pulse)
mm or inches: Above set value
×
pulse rate
Example: The following will be displayed as the Zone Setting Editing Screen
(hexadecimal display shown).
To Clear to Default
Settings Use the following procedure to clear specific setting to their default values.
(Refer to 4-2-4 Clearing Settings for details.)
1,2,3... 1. On the zone Setting Editing Screen, select the settings to be cleared to
their default values, or designate the range by clicking and dragging.
2. Select Edit/Clear
To Copy Axes For 2-axis and 4-axis NC Units, data can be copied from one axis to another
axis by selecting the source and destination axes. (Refer to 4-2-5 Copying
Axis Settings for details.)
1,2,3... 1. Select Edit/Copy Axis.
2. Under From and To, select the axes to be copied from and to respectively.
3. Click the OK Button.