9-3
Checking for Errors and Trouble-
shooting on the Support Software
Error management on the NX Series is based on the methods used for the NJ/NX/NY-series Control-
lers.
This allows you to use the Support Software to check the meanings of errors and troubleshooting pro-
cedures.
The confirmation method depends on the Support Software that is used.
9-3-1
Checking for Errors from the Sysmac Studio
When an error occurs, you can place the Sysmac Studio online to the Controller or the Communica-
tions Coupler Unit to check current Controller errors and the log of past Controller errors.
Refer to the user’s manual for the connected CPU Unit or Communications Coupler Unit for details on
how to check errors.
Current Errors
Open the Sysmac Studio’s Controller Error Tab Page to check the current error's level, source, source
details, event name, event codes, details, attached information 1 to 4, and correction.
Errors in the observation level are not displayed.
Additional Information
Number of Current Errors
The following table gives the number of errors that are reported simultaneously as current er-
rors in the High-speed Analog Input Units.
Unit
Number of simultaneous error notifications
High-speed Analog Input Unit
15 errors
If the number of errors exceeds the maximum number of reportable current errors, errors are
reported with a priority given to the oldest and highest-level errors. Errors that exceed the limit
on simultaneous error notifications are not reported.
Errors that are not reported are still reflected in the error status.
Log of Past Errors
Open the Sysmac Studio's Controller Event Log Tab Page to check the times, levels, sources, source
details, event names, event codes, details, attached information 1 to 4, and corrections for previous
errors.
Additional Information
Number of Logs of Past Errors
Event logs in the High-speed Analog Input Units are stored in the High-speed Analog Input
Units itself.
The system event log can record 15 events. The access event log can record 2 events.
9 Troubleshooting
9 - 5
NX-series Analog I/O Units User’s Manual for High-speed Analog Input Units (W592)
9-3 Checking for Errors and T
roubleshooting on the Support Software
9
9-3-1
Checking for Errors from the Sysmac Studio
Содержание Sysmac NX-series
