Omron SX-F, Инструкция по эксплуатации

Страница: 47 / 316

39
Remote control
Section 4-3
Fig. 34 Wiring
4-3-2 Switch on the mains
Once the mains is switched on, the internal fan in the VSD will run for 5 sec-
onds.
4-3-3 Set the Motor Data
Enter correct motor data for the connected motor. The motor data is used in
the calculation of complete operational data in the VSD.
Change settings using the keys on the control panel. For further information
about the control panel and menu structure, see the chapter SECTION 9
page 67.
Menu [100], Preferred View is displayed when started.
1. Press to display menu [200], Main Setup.
2. Press and then to display menu [220], Motor Data.
3. Press to display menu [221] and set motor voltage.
4. Change the value using the and keys. Confirm with .
5. Set motor frequency [222].
6. Set motor power [223].
7. Set motor current [224].
8. Set motor speed [225].
9. Set power factor (cos

) [227].
10. Select supply voltage level used [21B]
11. [229] Motor ID run: Choose Short, confirm with and give start com-
mand .
The VSD will now measure some motor parameters. The motor makes some beep-
ing sounds but the shaft does not rotate. When the ID run is finished after about
one minute ("Test Run OK!" is displayed), press
to continue.
12. Use AnIn1 as input for the reference value. The default range is 4-20 mA.
If you need a 0-10 V reference value, change switch (S1) on control board.
X2
X3
X1
1
12
22
11
41
42
43
31
32
33
51
52
2
3
4
5
6
7
8
9
10
13
14
15
16
17
18
19
20
21
Start
Reference
4-20 mA
+
0V