Omron Sti H-T40M-P, Инструкция по установке и эксплуатации, Страница: 10 / 21

M O U N T I N G P R O C E D U R E
6
10
H-T40m-P Manual Rev.A
6 M
OUNTING
P
ROCEDURE
6
1. Cut out the control front panel to match the dimensions (mm) specified
in the External and Cut-out-Dimensions section.
2. Mount the status display touchscreen into the cut-out. Insert the fixtures
to the holes on the unit and fasten the screws into the front of the panel. Do
not tighten the screws with too much or uneven force or it may cause the
deformation of the status display touchscreen.
Figure 6-1 Mounting
3. The status display touchscreen is to be installed within the angle of 0 to
135° as shown below.
Figure 6-2 Install Angle