Omron SmartController EX, Руководство пользователя

Страница: 37 / 72

Chapter 4: Operation
Table 4-7. Contacts Provided by the XFP Connector
Pin
Pairs Description Requirements for User-
Supplied Front Panel
Voltage-Free Contacts Provided by Customer
1, 9 Front Panel E-Stop CH 1 User must supply N/C con-
tacts
2, 10 Front Panel E-Stop CH 2 User must supply N/C con-
tacts
3, 11 Remote Manual / Automatic switch CH 1.
Manual = Open Automatic = Closed Optional - jumper closed for
Auto Mode-only operation
4, 12 Remote Manual / Automatic switch CH 2.
Manual = Open Automatic = Closed Optional - jumper closed for
Auto Mode-only operation
6, 14 Remote High Power ON / OFF momentary push-
button User must supply moment-
ary push-button to enable
High Power to system
Non-voltage-Free Contacts
5, 13 System-Supplied 5 VDC and GND for High Power
ON / OFF Switch Lamp User must supply lamp, or
use 1 W, 47 ohm resistor -
system will not operate if not
present
7, 15
a
Controller system 5 V power on LED, 5 V, 20 mA Optional - indicator only
8 No connection
PIN 8 PIN 1
PIN 9 PIN 15
See the figure Front Panel Schematic on page 41 for a schematic diagram of the Front Panel.
a
Users must exercise caution to avoid inadvertently connecting 24 V signals to these pins,
because this will damage the electronics.
NOTE: The system was evaluated by Underwriters Laboratory with a factory
Front Panel. If you provide a substitute Front Panel, this could void UL com-
pliance.
11069-000 Rev. H SmartController EX User's Guide 37