![background image](http://html.mh-extra.com/html/omron/scon-ca/scon-ca_connection-manual_1633416014.webp)
7
.
EtherCAT Connection Procedure
11
7. EtherCAT Connection Procedure
This section describes the procedure for connecting the Controller to the SCON-CA Controller
via EtherCAT.
This document explains the procedures for setting up the Controller and the SCON-CA
Controller based on the factory default setting. For the initialization, refer to
Section 8
Initialization Method
.
7.1. Work Flow
Take the following steps to perform PDO Communications of EtherCAT.
7.2. Setting up the IAI SCON-CA
Controller
Set up the IAI SCON-CA Controller.
↓
7.2.1. Hardware Settings
Set the hardware switches on the SCON-CA
Controller and connect the cables.
↓
7.2.2. Parameter Settings
Set the parameters for the SCON-CA Controller.
↓
7.3. Setting up the Controller
Set up the Controller.
↓
7.3.1. Starting the Sysmac Studio and
Installing the ESI File
Install the ESI file for the SCON-CA Controller in the
Sysmac Studio.
↓
7.3.2. Setting up the EtherCAT
Network Configuration
Set up the EtherCAT network configuration.
↓
7.3.3. Setting the Device Variables
Set the device variables used for the EtherCAT
Slave Unit.
↓
7.3.4. Transferring the Project Data
Transfer the project data from the Sysmac Studio to
the Controller.
↓
7.4. Checking the EtherCAT
Communications
Confirm that the PDO communications of EtherCAT
are performed normally.
↓
7.4.1. Checking the Connection Status Check the connection status of the EtherCAT
network.
↓
7.4.2. Checking the Sent and
Received Data
Confirm that the correct data are sent and received.
Содержание SCON-CA
Страница 40: ...2015 0115 1213 P585 E1 02 ...