Omron S8JX -, Техническое описание, Страница: 17 / 24

S8JX
17
Safety Precautions
Refer to Safety Precautions for All Power Supplies .
Minor electric shock, fire, or Product failure may
occasionally occur. Do not disassemble, modify, or
repair the Product to touch the interior of the
Product.
Minor burns may occasionally occur. Do not touch
the Product while power is being supplied or
immediately after power is turned OFF.
Fire may occasionally occur. Tighten terminal screws
to the specified torque of 1.13 N·m.
Minor injury due to electric shock may occasionally
occur. Do not touch the terminals while power is
being supplied. Always close the terminal cover after
wiring.
Minor electric shock, fire, or Product failure may
occasionally occur. Do not allow any pieces of metal
or conductors or any clippings or cuttings resulting
from installation work to enter the Product.
Mounting
•
Take adequate measures to ensure proper heat dissipation to
increase the long-term reliability of the Product.
•
Be sure to allow convection in the atmosphere around devices when
mounting. Do not use in locations where the ambient temperature
exceeds the range of the derating curve. (except 600 W)
•
The S8JX-
@
60024
@
is designed to radiate heat by means of
forced air-flow. Do not cover the air holes (provided at fan mounted
side and the opposite side) to have enough air-cooling.
•
The screws must not protrude more than 8 mm inside the Power
Supply when screw holes provided on the chassis are used. (300
W, 600 W)
Mounting screw tightening torque (recommended value) : 0.54 N
· m.
•
Rear mounting is possible using provided mounting bracket.
•
When cutting out holes for mounting, make sure that cuttings do
not enter the interior of the Products.
•
Improper mounting will interfere with heat dissipation and may
occasionally result in deterioration or damage of internal parts. Use
the standard mounting method only.
•
The internal parts may occasionally deteriorate and be broken due
to adverse heat radiation. Do not loosen the screw on the side face
of the main body.
•
When mounting two or more Power Supplies side-by-side, allow at
least 20 mm spacing between them.
•
Provide a space of at least 20 mm back and forth when mounting
300-W and 600-W models as well.
•
Use the metal plate as the mounting panel.
*1.
Convection of air
*2.
20 mm max.
*3.
Use a metal plate as the mounting surface.
CAUTION
Precautions for Safe Use
15-/35-/50-/100-/150-W Models
300-W Model
600-W Model
Standard Mo u nting
(Horizontal Mo u nting)
*
1
*
1
*
2
*
3
Standard Mo u nting
(Bottom-mo u nting)
*
1
*
1
*
2
*
3
*
1
*
2
*
1
Standard Mo u nting
(Front-mo u nting and DI N Rail-mo u nting)
*
1
*
1
*
1
*
3
*
2
*
2
Standard Mo u nting
(Bottom-mo u nting)
Standard Mo u nting
(Front-mo u nting and DI N Rail-mo u nting)
*
1
*
1
*
3