Omron R88D-KN01H-ECT-L, Руководство пользователя, Страница: 589 / 626

A - 143
Appendices
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
A-3
S
y
smac Error Sta
tus
Cod
es
A
A-3
-2 Error Des
c
ription
Event name External Latch Input Allocation Error Event code 384B 0000 hex
Description There is an error in the latch input function allocation.
Source
EtherCAT Master Function Module
Source
details
Slave
Detection
timing
When
establishing
communications
after turning ON
power to the
slave or when
transferring
EtherCAT
Configuration
Setup
Error
attributes
Level
Minor fault
Recovery
Error reset
(after cycling slave
power)
Log category
System
Effects User program Continues. Operation Power drive circuit is OFF for relevant slave.
Indicators
EtherNet/IP NET RUN EtherNet/IP NET ERR EtherNet/IP LINK/ACT
– – –
System
-defined
variables Variable Data type Name
None – –
Cause and
correction
Assumed cause Correction Prevention
The function was allocated to
input signals other than IN5, IN6,
or IN7. Allocate the latch input to input
signals IN5, IN6, or IN7. Allocate the latch input to input
signals IN5, IN6, or IN7.
A latch input is assigned to an NC
signal. Assign a latch input to an NO
signal. Assign a latch input to an NO
signal.
The same latch input is not
assigned to the same pin in all
Control Modes. Assign the same latch input in all
Control Modes. Assign the same latch input to the
same pin in all Control Modes.
Attached
information None
Precautions/
Remarks “33” is displayed on the Servo Drive front panel and F833 is given as the AlarmCode (4001 hex).