Omron Q2V Series, Техническое руководство

Страница: 698 / 734

12.10 o: KEYPAD
698 SIEPCYEUOQ2V01A Q2V Technical Manual
■
o1-36: LCD Backlight Brightness
No.
(Hex.)
Name Description
Default
(Range)
o1-36
(11B9)
RUN
LCD Backlight Brightness
Sets the intensity of the LCD keypad backlight.
3
(1 - 5)
When you decrease the setting value, the intensity of the backlight decreases.
■
o1-37: LCD Blight ON/OFF Selection
No.
(Hex.)
Name Description
Default
(Range)
o1-37
(11BA)
RUN
LCD Blight ON/OFF
Selection
Sets the automatic shut off function for the LCD backlight.
1
(0, 1)
Note:
Use o1-36 [LCD Backlight Brightness] to adjust the intensity of the LCD backlight.
0 : OFF
1 : ON
Enables the automatic shut off function. The backlight will automatically turn off after the time set in o1-38 [LCD
Blight Off-Delay] is expired.
Note:
When o1-37 = 1 and the backlight is OFF, the keys other than are disabled.
When the backlight is off, push a key on the keypad to temporarily turn the backlight on. Push any key to start keypad operation, Push
to turn the backlight on, then push again to enter a Run command to the drive.
■
o1-38: LCD Blight Off-Delay
No.
(Hex.)
Name Description
Default
(Range)
o1-38
(11BB)
RUN
LCD Blight Off-Delay
Sets the time until the LCD backlight automatically turns off.
60 s
(10 - 300 s)
When o1-37 = 1 [LCD Blight ON/OFF Selection = ON] , the backlight will automatically turn off after the time
set in o1-38 expires.
When the backlight is off, push a key on the keypad to temporarily turn the backlight on. After the backlight turns
on, it will turn off automatically after the time set in
o1-38 is expired.
■
o1-39: Show Init Screen
No.
(Hex.)
Name Description
Default
(Range)
o1-39
(11BC)
RUN
Show Init Screen
Sets the function to show the LCD keypad initial setup screen each time the drive is energized.
This parameter is only available when using an LCD keypad.
1
(0, 1)
The initial setup screen shows a menu where you can select the display language, set the date, time, and other
basic settings. When you set this parameter to 0, the drive will not show this screen each time you energize the
drive.
0 : No
The drive will not show the initial setup display screen each time you energize the drive. The drive will show the
Home screen.
1 : Yes
When you input the Run command before you energize the drive or when the you turn on the Run command while
the drive shows the initial setup screen, the drive will replace the initial setup screen with the Home screen.
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV