Omron NY532-1*00-111*13**0, Руководство пользователя, Страница: 25 / 214

FirstOnPosition LastOnPosition
OffCompensation
LastOnPosition after compensation
Restoring Data
• The absolute encoder home offsets are backed up with a non-volatile memory in the product as ab-
solute encoder information. If any of the following conditions is met, clear the absolute encoder
home offsets from the list of data items to restore, and then restore the data. Then, define the abso-
lute encoder home again. If you do not define home, unintended operation of the controlled system
may occur.
• The Servomotor or Servo Drive was changed since the data was backed up.
• The absolute encoder was set up after the data was backed up.
• The absolute data for the absolute encoder was lost.
• You can partially or cannot at all back up, restore, or compare data of the settings depending on
slaves and Units. Also, you cannot back up, restore, or compare data for disabled slaves or Units.
After you restore data, sufficiently confirm that operation is correct before you start actual operation.
Battery Replacement
• Dispose of any Battery that has been dropped on the floor or otherwise subjected to excessive
shock. Batteries that have been subjected to shock may leak if they are used.
• UL standards require that only an experienced engineer replace the Battery. Make sure that an ex-
perienced engineer is in charge of Battery replacement.
• The Battery may leak, rupture, heat, or ignite. Never short-circuit, charge, disassemble, heat, or in-
cinerate the Battery or subject it to strong shock.
Product Replacement
• Make sure that the required data, including the user program, configurations, settings and variables
is transferred to a product that was replaced and to externally connected devices before restarting
operation.
Be sure to include the tag data link settings and routing tables, which are stored in the product.
Cleaning, Maintenance and Disposal
• Do not use corrosive substances to clean the product. Doing so may result in the failure or malfunc-
tion.
• Periodically check the installation conditions in applications where the product is subject to contact
with oil or water.
• As the rubber gasket will deteriorate, shrink, or harden depending on the operating environment, pe-
riodical inspection is necessary.
• Dispose of the product and batteries according to local ordinances as they apply.
Precautions for Safe Use
23
NY-series Industrial Panel PC Hardware User's Manual (W557)