Omron NJ501-5300, Инструкция и справочник, Страница: 67 / 142

2 - 29
2 G Code
NJ/NY-series G code Instructions Reference Manual (O031)
G
53
Di
m
ens
io
n Sh
ift
C
anc
el
2
Parameters
G53 Dimension Shift Cancel
This instruction runs commands in the machine coordinate system.
This command runs rapid positioning commands in the machine coordinates, i.e., coordinates without
compensation. The command values are always handled as absolute values, and other movement
behaviors follow G00 Rapid Positioning.
This command releases Scaling (G50/G51), Mirroring (G50.1/G51.1), Coordinate System Rotation
(G68/G69), and the Local Coordinate System Set (G52). It temporarily releases Zero Shift (G54 to G59)
during operation, and maintains the current status of Inch Input/Metric Input (G20/G21). Tool Offset
(G43/G44/G49) and Cutter Compensation (G40/G41/G42) must be released prior to execution of this
command.
Modal/Non-modal Non-modal
Modal group 00 Non-modal
Instruction format G53 X- Y- Z- A- B- C-
Relevant G codes
G50, G51, G50.1, G51.1, G68, G69, G52, G54 to G59, G40, G41, G42, G43, G44,
G49
Parameters
Parameter Name Description
X Target X-axis Position Specifies the destination position [command units] on the
X-axis.
Y Target Y-axis Position Specifies the destination position [command units] on the
Y-axis.
Z Target Z-axis Position Specifies the destination position [command units] on the
Z-axis.
A Target A-axis Position Specifies the destination position [command units] on the
A-axis.
B Target B-axis Position Specifies the destination position [command units] on the
B-axis.
C Target C-axis Position Specifies the destination position [command units] on the
C-axis.
Function