Omron K6PM-TH, Руководство пользователя

Страница: 63 / 198

3 - 7
3 Initial Setting
K6PM-TH Thermal Condition Monitoring Device User’s Manual (H231)
3-2 IP
Ad
dress Set
ting
3
3-
2-1 IP
Address
S
e
tting o
f Y
our PC
3-2 IP Address Setting
This section describes the setting of the IP address of your PC and each IP address of the Main Units.
Before starting this tool and monitoring and logging the Main Unit, it is necessary to set the IP address
of the computer to the IP address of the same segment as the Main Unit. It shows the procedure.
Note that when setting only the Main Unit with an automatic connection, it is not necessary to set the IP
address on the computer side.
For the initial setting of K6PM-TH, refer to 3-2-2 Setting the IP Address of the Main Units with the Soft-
ware Tool on page 3-9.
 Windows 7
1
Select Start | Control Panel | Network and Internet | Network and Sharing Center | Change
Adapter Settings .
2
Right-click Local Area Connection and select Properties .
3
Select Internet Protocol Version 4 (TCP / IPv4) and click Properties .
Check “Use next IP address” and manually set the IP address of the computer.
 Windows 8.1
1
Right-click Start .
2
Select Network connection .
3
Right-click Ethernet , and click Properties .
4
Select Internet Protocol Version 4 (TCP / IPv4) and click Properties .
Check “Use next IP address” and manually set the IP address of the computer.
 Windows 10
1
Click Start and select Windows System Tools | Control Panel .
2
Select Network and Internet | Network and Sharing Center | Change Adapter Settings .
3
Right-click Ethernet and click Properties .
4
Select Internet Protocol Version 4 (TCP / IPv4) and click Properties .
Check “Use next IP address” and manually set the IP address of the computer.
3-2-1 IP Address Setting of Your PC