Omron FQ2 Series, Руководство пользователя

Страница: 123 / 516

Inspecting with the Edge Position Inspection Item
FQ2 User’s Manual
4
Settin
g Up In
spections
121
Step 2 Teaching
Teaching means to store the region and the edge position in the region as reference data for the measurement.
[Inspect]
−
[Inspection]
−
[Add item.]
−
[Edge Position]
−
[Settings] Tab Page
The following data is stored as basic measurement data.
Step 3 Adjusting Judgement Parameters
[Inspect]
−
[Inspection]
−
[Add item.]
−
[Edge Position]
−
[Settings] Tab Page
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured.
4
Press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed.
6
Press [Back] to end teaching.
Changing the measurement region: p. 102
Item Parameter Description
Reference data Reference position X The reference coordinates (X, Y) of the position are set automatically.
Reference position Y
1
Press [Judgement].
2
Press the parameters and set the range that is to be
judged as OK.
The measurement value is displayed next to the param-
eter name. Continuous measurements will be performed
for the images that are displayed.
3
Press [OK] to enter the value.
Parameter Setting Description
Position X Range:
−
99,999.9999 to 99,999.9999
Defaults: Lower limit:
−
99,999.9999, Upper limit: 99,999.9999
Adjust the upper and lower limits of edge
position X for an OK judgement.
Position Y Range:
−
99,999.9999 to 99,999.9999
Defaults: Lower limit:
−
99,999.9999, Upper limit: 99,999.9999
Adjust the upper and lower limits of edge
position Y for an OK judgement.
• You can change the output form for each measurement value to one of the following settings.
Press
[ ]
−
[Result type] on the right of the display.
Absolute value (default): The measured coordinates are output as absolute values.
Relative value: The difference from the reference value is output.
Mo v es the end point
of the meas u rement
region.
The arro w in the middle sho w s the
direction for detecting an edge.
Changes the w idth
of the meas u rement
region.
Mo v es the starting
point of the
meas
u rement region.
Drag to mo v e
the region.
Bl u e for OK. Red for N G.
Lo w er limit
Upper limit
You can change the parameters for judgement conditions on the
Display Settings Display. Press
[ ]
−
[Display setting] on the right
of the display to switch to the Display Settings Display.
Note
Note