Omron FQ2-S4, Руководство пользователя, Страница: 146 / 594

Inspecting with the Search Inspection Item
144
FQ2-S4 User’s Manual
Changing the Measurement Region
The region within which the model is searched can be changed. In the default settings, the whole display is set
as the measurement region.
[Inspect]
−
[Inspection]
−
[Search]
−
[Modify]
−
[Settings] Tab Page
−
[Teach]
Changing Output Coordinate Positions
You can specify which part of the model to detect as coordinates during inspections. Normally, the center
position of the registered model is used as the detection point.
[Inspect]
−
[Inspection]
−
[Search]
−
[Modify]
−
[Settings] Tab Page
−
[Teach]
−
[ ]
−
[Detection point]
1
Press [ ]
−
[Insp. region] on the right of the display.
The [Insp. region] Display will appear.
2
Adjust the size and position of the measurement re-
gion.
• Change the size.
Press the frame at one corner.
The processing time can be shortened by making the
region smaller.
• Change the position.
Drag the figure to move it.
1
Use one of the following methods to move the cross
cursor to the desired position.
The position of the cross cursor will be the coordinate
position that is output. This position is registered rela-
tive to the model region.
• Drag the cross cursor to move it.
• Press
[ ]
−
[Console] on the right of the display to dis-
play the console. You can use the cross cursor on the
console to change the coordinate values one pixel at a
time.
The detection coordinates will automatically return to the center coordinates of the model if you change the model
region.
Drag the cross cursor.
Note