Omron FQ2-S/CH Series, Руководство пользователя

Страница: 576 / 590

Connecting a Previous Touch Finder (FQ-D30/D31) to the FQ2-S Sensor
574
FQ2-S/CH User’s Manual
9-5 Connecting a Previous Touch Finder (FQ-D30/D31) to the FQ2-S Sensor
FQ2-S1 FQ2-S2 FQ2-S3 FQ2-S4
If you update the previous FQ-D30/D31 Touch Finder to version 1.6 or higher, you can connect it to an FQ2-S
Sensor. However, the memory size that is required to use all of the filter items, position compensation items,
and inspection items exceeds the memory capacity of the previous FQ-D30/D31 Touch Finder, so you will not
be able to use all of the filter items, position compensation items, and inspection items that are provided in the
FQ2-S Sensor.
Therefore, it is necessary to select only the filter items, position compensation items, and inspection items that
you need to use and register them in the Sensor.
If you connect the Touch Finder without doing this, the Touch Finder may freeze as soon as it is connected or
during operation.
Apart from the filter items, position compensation items, and inspection items, you can use all of the functions
of the Sensor.
Download the update file for the Touch Finder (version 1.6 or higher) and the FQ Item Selector from the
member website, and then use the following procedures to update the Touch Finder and register the filter
items, position compensation items, and inspection items in the Sensor.
http://www.omron-cxone.com/vision_sys
• Updating the Touch Finder
1
Place the update file directly in the root folder of an SD card.
2
Insert the SD card into the Touch Finder.
3
Press (Setup Mode or Run Mode) − [TF settings] − [Update].
The Touch Finder will be updated automatically.
Do not turn OFF the power supply until updating the Touch Finder has been completed.
The Touch Finder may not start normally if power is turned OFF during the update.
Important