Omron FQ2-S/CH Series, Руководство пользователя

Страница: 109 / 590

Adjusting the Images That Were Taken FQ2-S/CH User’s Manual
107
3
Ta
ki
ng Ima
ges
Shape Search lll Position Compensation
With this position compensation item, an image pattern is registered in advance. When the registered image
pattern is detected, the image is adjusted so that the image pattern is in the same position as when it was
registered.
This position compensation item performs the same type of processing as the Search Position Compensation
item, but it performs special processing for the shape of the image pattern.
Use this position compensation item to correct the position of a rotated image pattern.
[Image] − [Image adjustment]
• Detailed Settings for Shape Search Position Compensation
The settings for the Shape Search lll Position Compensation item are almost the same as those for the Shape
Search II inspection item. Only the [Sorting method] settings of the Search item are not included in the settings
of the Shape Search Position Compensation item.
Configure the settings for teaching and the judgment conditions in the same way as for the Shape Search II
item.
4-9 Inspecting with the Shape Search III Inspection Item: p. 230
Also, the following settings are included only in the Shape Search lll Position Compensation Item.
• Source Image
You can select the image to which to apply the results of position compensation processing.
Applying the Results of Position Compensation: p. 104
1
Press an unused number and then press [Add pos. comp.].
2
Press [Model]
−
[Shape lll. pos. comp.]
3
Make any detailed settings as required for
the position compensation processing.
Refer to Detailed Settings for Shape Search lll Po-
sition Compensation , below.
4
Press [OK].
5
Press [Back].