Omron F3SG-RA, Руководство пользователя

Страница: 222 / 268

198
Ch
apt
e
r
5
Wir
ing
Ex
amples
(F3
S
G-
RA
Series
)
F3SG-R
User’s Manual
Input/Output Circuit and Applications
5-2-2-3. Standard Muting Mode/Exit-Only Muting Mode with two Muting
Sensors using PNP Outputs
The following is the example of External Device Monitoring disabled, Auto Reset mode, PNP output
and External Test in 24 V Active.
[DIP Switch settings] *5
 : Indicates a switch position.
Configure functions with the DIP Switches before wiring.
[Wiring Example]
Function DIP-SW1 DIP-SW2
Receiver
EDM Disabled (factory default setting)
Auto Reset (factory default setting)
PNP (factory default setting)
Emitter External Test: 24 V Active (factory default setting)
㻞 㻻㻺 㻞 㻻㻺
㻟 㻻㻺 㻟 㻻㻺
㻠 㻻㻺 㻠 㻻㻺
㻣 㻻㻺 㻣 㻻㻺
㻠 㻻㻺
OSSD
1 : Black
OSSD
2 : White
24
VDC : Brown
Not used : Yellow TEST
:
Black
Not used : White 24
VDC : Brown
0
VDC : Blue
Receiver
Emitter
0
VDC : Blue
AUX : Red MUTE B
: Pink
MUTE A
: Gray
RESET : Yello
w *1
S1: Test Switch (Connect the line to 0 V if this switch is not required)
S2: Lockout/Interlock Reset Switch,Override Switch or Override Cancel Switch
A1, B1: Muting sensor
S1
S2
*2
Muting
Sensor
(PNP
output)
Reflector
F39-JG A-L F39-JG A-D
A1
B1
Power Supply
+24 VDC
0 VDC
Safety
Controller *3 *4
IN1 IN2
Unblocked
Blocked
MUTE A
MUTE B
OSSD
Test Switch (S1)
Beam state
PLC *6
IN
*1. Also used as Override input line.
*2. Make sure to connect an override cancel switch to the
Reset line when using the override function. Otherwise
the override state may not be released by the override
cancel switch, resulting in serious injury.
*3. Refer to 5-4. Connectable Safety Control Units for
more information.
*4. The safety controller and the F3SG-R must share the
power supply or be connected to the common terminal
of the power supply.
*5. The functions are configurable with DIP Switch. Refer
to Chapter 3 Setting with DIP Switch for more
information on setting the functions by the DIP Switch.
*6. When connecting to the PLC, the output mode must be
changed with the Configuration Tool according to your
application.