Omron F3SG-RA, Руководство пользователя

Страница: 219 / 268

195
F3SG-R
User’s Manual
Ch
apt
e
r
5
Wir
ing
Ex
amples
(F3
S
G-
RA
Series
)
Input/Output Circuit and Applications
E
5-2-1-4. Pre-Reset Mode using PNP Output
The following is the example of External Device Monitoring disabled, Pre-Reset mode, PNP output and
External Test in 24 V Active.
[DIP Switch settings] *4
 : Indicates a switch position.
Configure functions with the DIP Switches before wiring.
[Wiring Example]
Function DIP-SW1 DIP-SW2
Receiver
EDM Disabled (factory default setting)
Pre-Reset
PNP (factory default setting)
Emitter External Test: 24 V Active (factory default setting)
㻞 㻻㻺 㻞 㻻㻺
㻟 㻻㻺 㻟 㻻㻺
㻠 㻻㻺 㻠 㻻㻺
㻣 㻻㻺 㻣 㻻㻺
㻠 㻻㻺
OS
SD1 : Black
OS
SD2 : White
24 VDC : Brown Not used : Yellow TEST : Black Not used : White 24 VDC : Brown 0 VDC : Blue
Receiver
Emitter
0 VDC : Blue AUX : Red Not used : Pink
PRE-RESET : Gray
RESET : Yellow
S1: Test Switch (Connect the line to 0 V if this switch is
not required)
S2: Lockout/Interlock Reset Switch
S3: Pre-Reset Switch
PLC: Programmable controller
(Used for monitoring only. NOT related to safety system.)
S2 S3
F39-JG A-L F39-JG A-D
S1
Power Supply
+24 VDC
0 VDC
Safety
Controller *1 *2
IN1 IN2
PLC *3
IN
Pre-Reset Switch (S3)
Beam state
Reset Switch (S2)
OSSD
Unblocked
Blocked
T1: Push time: must be T1 >= 300ms
T2: Pre-reset limit time between Pre-reset and Reset: must be T2 <= 60s
T3: Push time: must be T3 >= 300ms
T1
T2
T3
*1. Refer to 5-4. Connectable Safety Control Units for more information.
*2. The safety controller and the F3SG-R must share the power supply or be connected to the common terminal
of the power supply.
*3. When connecting to the PLC, the output mode must be changed with the Configuration Tool according to
your application.
*4. The functions are configurable with DIP Switch. Refer to Chapter 3 Setting with DIP Switch for more
information on setting the functions by the DIP Switch.