Omron F3SG-PG Series, Руководство пользователя

Страница: 415 / 473

385
F3SG-SR/PG
User’s Manual
Chapter
6
Wiring Exa
m
p
le
s
(f
or F3
SG-SR/PG)
Input/Output Circuit and Applications
E
6-2-1-2. Auto Reset Mode with Wired Synchronization and EDM Unused
[Wiring Example (F3SG-SR and F3SG-PGA-A/-L)]
• When a functional earth is necessary, wire an earth cable according to the example in 6-2-1-1. Auto Reset Mode with
Optical Synchronization and EDM Unused . Also refer to 5-4-4. Functional Earth Connection for more information.
F3SG-SRA

F3SG-PGA-A/-L

F3SG-SRB

F3SG-PGA-C
Beam state: Unblocked
Blocked
OSSD
OSSD (Black) OSSD (White) 24V/0V (Brown) COM(-) (Yellow) TEST (Black) *2 COM(+) (White) 24V/0V (Brown) 0V/24V (Blue) 0V/24V (Blue) AUX (Red) COM(-) (Pink) COM(+) (Gray)
F39-JG C-L
F39-JG C-D
Timing chart
24 VDC
Wiring for NPN *1
24 VDC
IN1 IN2
RESET/EDM (Yellow) *3
*6
Receiver
Emitter
Safety controller
*4 *5
*1. Reverse the polarity of the power supply when using in the NPN system. Select a safety controller
of PNP or NPN type according to the system of your application.
*2. Refer to 2-6. External Test for more information if External Test is used.
*3. Connect the line to 24V/0V (brown) of the receiver via a lockout reset switch (NC contact) if
Lockout Reset is used.
*4. Refer to 6-3. Connectable Safety Control Units for moreinformation.*6
*5. The safety controller and the F3SG-SR/PG must share the power supply or be connected to the
common terminal of the power supply.
*6. This is the case for a PELV circuit.
Function Setting
EDM EDM Disabled (factory default setting)
Interlock Auto Reset (factory default setting)
Operating Range Selection Long (factory default setting)
Non-Muting system Perform wiring according to the wiring diagram.
External Test not used Connect the TEST line of the emitter to 0V/24V of the emitter.
Optical Synchronization Connect the COM(+) and COM(-) line of the emitter and receiver with each other.
Intelligent Tap Not Needed