Omron EQ100-E, Руководство пользователя

Страница: 210 / 256

11. Safe Mode
11-1
Safe Mode 11.
The safe mode is for maintenance to recover an EQ100 failure.
Under the safe mode, the following operations are available:
- Checking EQ100 information
- Checking LAN/sub-LAN connection port settings
- Clearing setting/stored data
- Updating the firmware
- Clearing logs
- Recovering to the factory shipment status
11.1. Startup in Safe Mode
Shown below are the steps to start up EQ100 in the safe mode:
1) While the power is ON, configure the setup DIP switch SW10 of EQ100 on the front end as
ON.
2) Use a very fine screwdriver or other tools to press and hold the reset button on the EQ100
front end for 1 second or longer.
A buzzer is sounded and the power of EQ100 is turned on again, then activated under the safe
mode.
Under the safe mode, the operation status indicator on the EQ100 front end flashes and stays
on alternately in three second cycle.
3) Connect a LAN cable between the computer and the LAN connection port of EQ100.
Configure the computer's IP address as shown below.
IP Address 192.168.200.***
Subnet Mask 255.255.255.0
Default Gateway Setting not required
Precautions for
Correct Use
- For "***", specify a number from 2 to 199 or from 201 to 254. You cannot use 0 and 25.
Specify an IP address that is not used for EQ100 itself and measurement devices connected
to the LAN connection port of EQ100.
Reset Button