Omron CX-One 1.1, Руководство по установке

Страница: 15 / 51

xvi
Intended Audience 1
1 Intended Audience
This manual is intended for the following personnel, who must also have
knowledge of electrical systems (an electrical engineer or the equivalent).
• Personnel in charge of installing FA systems.
• Personnel in charge of designing FA systems.
• Personnel in charge of managing FA systems and facilities.
2 Safety Precautions
!Caution
When performing any of the following operations, always check the network
address and node address of the other node (PLC) and the node address and
unit number of the mounted Unit (PLC CPU Bus Unit or Special I/O Unit) or
the node address of the Component (DeviceNet Master/Slave or Compo-
Way/F Slave), and be sure that these operations can be performed safely for
the current status of the node (Unit or Component):
• Transferring parameter or program data to the other node
• Changing the operating mode of the other node
Unexpected operation may result if parameter or program data is transferred
to the wrong node (DeviceNet Master/Slave or CompoWay/F Slave), the oper-
ating mode of the wrong node is changed, or the other node is not in a suit-
able status to receive the program or parameter data or the operating mode
change.
!Caution Particularly when changing the target PLC to any PLC other than the relay
PLC, check the node address and node number of the target PLC carefully
before executing the change.) Unexpected operation and injury may result if
the wrong PLC is set as the target PLC.
• Changing the operating mode
• Transferring or verifying user-set data link tables
• Transferring or verifying routing tables
• Performing I/O table operations (including transferring CPU Bus Unit or
Special I/O Unit parameters)
Note Operations performed from the CX-Integrator are performed for the target
PLC, which is not necessarily the same as the relay PLC.
!Caution When transferring parameters that have been created or edited on the com-
puter to actual Units (PLC CPU Bus Units or PLC Special I/O Units) or to
actual components (DeviceNet Masters/Slaves or CompoWay/F Slaves), or
when resetting Units mounted on other PLC nodes or components (DeviceNet
Masters/Slaves or CompoWay/F Slaves) connected via communications with
other PLC nodes, always check the identifying numbers of the actual Units or
Components (i.e., the unit numbers and unit addresses or node addresses)
before executing the transfer or reset. Unexpected operation and injury may
result if parameters are transferred to the wrong Unit or components, or the
wrong Unit or component is reset.