35
Installation
Section 3-2
• When mounting a relay output unit on the very left of the MC Unit, make
sure to use the surge absorber for the relay output line.
3-2-2
Mounting to the Backplane
CJ1W-MCH71
Use the following steps to mount or remove MC Units.
The Units that make up a CJ-series PLC can be connected simply by pressing
the Units together and locking the sliders by moving them toward the back of
the Units. The End Cover is connected in the same way to the Unit on the far
right side of the PLC. Follow the procedure listed below to connect PLC com-
ponents.
1,2,3...
1.
The following diagram shows the connection of two Units that make up a
CJ-series PLC. Join the Units so that the connectors fit exactly.
2.
The yellow sliders at the top and bottom of each Unit lock the Units togeth-
er. Move the sliders toward the back of the Units as shown below until they
click into place.
Note
If the locking tabs are not secured properly, the CJ-series may not
function properly. Be sure to slide the locking tabs until they are se-
curely in place.
MC Unit
Make sure to use a surge absorber for the
contact output of this Relay Output Unit.
PA205R
POWER
INPUT
AC100-240V
L2/N
L1
DC24V
AC240V
OUTPUT
RUN
PERIPHERAL
ERR/ALM
RUN
INH
COMM
PRPHL
CONTROLLER
CJ1G-CPU44
SYSMAC
PROGRAMMABLE
PORT
OPEN
BUSY
MCPWR
Connector
Hook
Hook holes
PA205R
POWER
INPUT
AC100-240V
L2/N
L1
DC24V
AC240V
OUTPUT
RUN
PERIPHERAL
ERR/ALM
RUN
INH
COMM
PRPHL
CONTROLLER
CJ1G-CPU44
SYSMAC
PROGRAMMABLE
PORT
OPEN
BUSY
MCPWR
Lock
Release
Slider
Move the sliders toward the back
until they lock into place.
Содержание CS1W-MCH71 -
