Omron CS1W-HCA12-V1, Руководство по эксплуатации

Страница: 98 / 254

78
Unit Setup Area
Section 5-1
5-1 Unit Setup Area
5-1-1 Overview
The Unit Setup Area enables the user to set the functions of the Customizable
Counter Unit through initial software settings. Connect a Programming Device
to the Unit’s peripheral port and make the settings in DM 6600 to DM 6655 of
the Unit’s DM Area.
Note It is not possible to make the settings for the Unit Setup Area in the Customiz-
able Counter Unit from a CX-Programmer using the PLC Setup functions.
Make the settings for in DM 6600 to DM 6655 from the PLC Memory Window
on the CX-Programmer.
Unit Setup Area The Unit Setup Area consists of DM 6600 to DM 6655. These words are
divided according to function and enable timing as shown below.
Default Settings The default setting (factory setting) for all words in the Unit Setup Area is
0000.
Resetting All words in the Unit Setup Area can be reset to 0000 by turning ON
SR 25210 (Unit Setup Area Reset Bit) using the Programming Device in PRO-
GRAM mode.
Note 1. When the DM Area is cleared by performing the memory clear operation
from a Programming Console, the Unit Setup Area is also reset.
2. The Unit Setup Area can also be read from the user program. It cannot,
however, be written from the user program. Write to the User Setup Area
using a Programming Device.
3. The Unit Setup Area settings are saved in flash memory. Therefore, even
if the super-capacitor’s saving time elapses, the data will be saved.
Address Function Enable timing Operation for setting error
DM 6600 to DM 6604 Overall Unit Settings Enabled at Startup SR 24900 turns ON.
DM 6605 to DM 6614 Special I/O
DM 6615 to DM 6629 Overall Unit Settings Enabled at Startup and when
operation starts SR 24901 turns ON.
DM 6630 to DM 6639 Special I/O
DM 6640 to DM 6644 Overall Unit Settings
DM 6645 to DM 6655 Overall Unit Settings Enabled whenever changed SR 24902 turns ON.