161
Virtual Pulse Output Function (-V1 unit with lot No. 0209__or later only)
Section 7-10
7-10 Virtual Pulse Output Function (-V1 unit with lot No.
0209__or later only)
7-10-1 Applicable Models
7-10-2 Overview
PLS2 instruction enables the execution of virtual pulse output with trapezoidal
acceleration/deceleration (virtual pulse output mode).
PLS2 instruction executes the pulse output with trapezoidal acceleration/
deceleration internally. At the same time, it integrates (counts) the pulse
amount (an area) for the trapezoid internally.
With this function, the "virtual axis position" defined by the internal pulse
counts can be applied to various applications.
Ex 1) Position/speed
Control Corresponding to
Virtual Axis (Electronic
Cam Operation)
The internal pulse counts being defined as a virtual axis, it is possible to exe-
cute the electronic cam operation (position and speed control corresponding
to the virtual axis angle) based on the approximated curve corresponding to
the virtual axis.
Ex 2) Electronic Gear
Corresponding to the
Calculated Speed of the
Virtual Axis (Pulse
Synchronous Control)
The internal pulse counts being defined as a virtual axis, the unit calculates
the speed of the virtual axis with such a ladder program. The value (speed)
with a certain multiplication can be output as a pulse (Electronic gear func-
tion). This enables the synchronous control based on a virtual axis.
Model numbers
Functions
CS1W-HCP22-V1
12 contact inputs, 8 contact outputs, 2 pulse inputs, 2 pulse outputs
CS1W-HCA22-V1
12 contact inputs, 8 contact outputs, 2 pulse inputs, 2 analog outputs
CS1W-HCA12-V1
12 contact inputs, 8 contact outputs, 1 analog input, 1 pulse input, 2 analog
outputs
PLS2
P
D
T
AR1915
PLS2 instruction
mode change
Ladder program
Customizable counter unit model CS1W-HCP22-V1
Switches PLS2 instruction mode to virtual pulse output mode
(Note: Needed only with the model CS1W-HCP22-V1)
Internal pulse frequency
(speed command)
Target frequency
(Hz)
Specified pulse amount = Target position
Target position
and frequency
Virtual axis
Time
Pulse counts
(Internal present position)
Electronic cam operation, etc using PULS
instruction corresponding to the pulse count
present value
=
Содержание CS1W-HCA12-V1
