![background image](http://html1.mh-extra.com/html/omron/cs1w-hca12-v1/cs1w-hca12-v1_operation-manual_741977131.webp)
111
AR Area
Section 6-4
AR 08
00
High-speed counter 1
status
Target Value
Comparison
Flag
OFF: In Target Comparison Mode
for the CTBL instruction, indicates
that comparison is not in progress.
Note:
This flag is always OFF in
range comparison mode for the
CTBL instruction.
ON: In Target Comparison Mode for
the CTBL instruction, indicates that
comparison is in progress.
Note:
Unlike range comparison,
once target value comparison is
started, it is continuously executed.
This bit can be used to confirm
whether or not comparison is actu-
ally in progress.
Unit
Enabled
01
Overflow/
Underflow
Flag
OFF: In Linear Counter Mode, there
is no overflow or underflow. In Ring
Counter Mode, this flag is always 0.
ON: In Linear Counter Mode, an
overflow or underflow has occurred.
The high-speed counter PV is fixed
at one of the upper limits. This flag is
cleared when the High-speed
Counter Start Bit is turned OFF.
02
(Reserved
by system.)
---
03
Phase-Z
Input Reset
Flag (ON for
one cycle)
If the high-speed counter reset
method is phase Z + software reset
(1 Hex is set in bits 04 to 07 in
DM 6605), this flag turns ON for one
cycle when the high-speed counter’s
PV is reset.
Note:
If the phase-Z signal (reset
input) turns ON while the High-
speed Counter Reset Bit (bit 01 in
AR 09) is ON, this flag turns ON for
one cycle when the high-speed
counter’s PV is reset.
04
ABS PV read status
ABS No. of
rotations
read error
0: No error
1: Error occurred
05
ABS No. of
rotations
read com-
pleted
0: Not reading or reading
1: Reading completed (This is set at
the completion of receiving serial
data on No. of rotations.)
Address
Bits
Function
Details
Controlled
by
Forced
set/reset
Содержание CS1W-HCA12-V1
