![background image](http://html1.mh-extra.com/html/omron/componett-e3nw-crt/componett-e3nw-crt_user-manual_742285061.webp)
59
E3NW-CRT
User’s Manual
Section 3
CompoNet
Commun
ic
a
tio
ns
Spec
if
icat
ions
Section 3
Explicit Message Communications
*1:The valid unit number range for the instance ID is 0001 to 0020 hex.
Error Codes
One-point Tuning
Performs one-point tuning.
0x9E
Unit No./
Output
0xDE
NA
NA
OK
Flashing
Flashes the light.
0x9E
Unit No.
0xDF
OK
OK
OK
Clear Flashing
Stops flashing of the light.
0x9E
Unit No.
0xE0
OK
OK
OK
Initialize
Resets all internal Sensor
Amplifier Unit set values to their
default settings.
0x9E
Unit No.
0x45
OK
OK
OK
Tuning without a
Workpiece
Performs tuning without a
workpiece.
0x9E
Unit No./
Output
0xE2
NA
NA
OK
Explicit message
Function
Command
Applicable Sensor
Amplifier Units
Class
ID
Instance
ID
Attribute
ID
FA0
LA0
SA0
Response code
Error name
Cause
0x08FF
Service
not supported
An error was detected in the service code.
0x14FF
Invalid
Attribute value
The specified attribute value is not supported.
The written data is out of range.
• The number of connected Sensors is not within between 1 and 16.
• The number of Units specified for detection level monitoring is not
between 1 and 16.
0x16FF
Object
does not exist
The specified instance ID is not supported.
• The unit number specified in the instance ID exceeds the number of
connected Sensors.
0x15FF
Too much data
The data is longer than the specified size.
0x13FF
Not enough
data
The data is shorter than the specified size.
0x0CFF
Object state
conflict
The specified command cannot be executed.
• An error occurred in communications with the Sensor Amplifier Unit.
• The Sensor Amplifier Unit is not in Detection Mode.
• A command was sent to perform second-point tuning for two-point
tuning or positioning tuning without performing tuning for the first point.
• An unsupported command was sent. (For example, a command to read
digital values was sent to a Terminal Block Unit.)
0x20FF
Invalid
Parameter
The specified operation execution data is not supported.
0x0EFF
Attribute
not settable
A write service code was sent with a read-only attribute ID.
OK: Supported,
NA: Not supported, ---: To communication unit
Содержание CompoNetT E3NW-CRT
Страница 1: ...CompoNet TM Digital Sensor Communications Unit E3NW CRT Cat No E430 E1 04 User s Manual ...
Страница 14: ...12 Introduction E3NW CRT User s Manual Introduction Reading This Manual ...
Страница 18: ...16 E3NW CRT User s Manual Introduction Contents Introduction MEMO ...
Страница 101: ......