Omron CJ1W-SCU22, Руководство по эксплуатации, Страница: 417 / 478

R-83
A Standard System Protocol
CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)
R-
5 3
Z
4
L
Lase
r
Mi
cr
omet
er
Pr
otoc
o
l
Re
f
R
-5-3
Protocol
Configur
ation
The configuration of the 3Z4L Laser Micrometer Protocol is shown below.
R-5-3 Protocol Configuration
Sequence
No.
Communications sequence
name
Function Ladder interface
Send word
allocation
Receive
word alloca-
tion
400 (0190) 3Z4L clear Resets errors, data, analog output, deci-
sion result and places the Laser
Micrometer into standby. No No
401 (0191) Memory switch set Sets memory switches and the area for
the work position LED. Yes No
402 (0192) mm unit set Sets the display unit to mm. No No
403 (0193) E unit set Sets the display unit to E. No No
404 (0194) Calibration set Calibrates the Laser Micrometer.
Calibration setting release.
Yes No
405 (0195) Calibration release Releases the calibration of the Laser
Micrometer. No No
406 (0196) Program number set
(3000-series) Switches the program number to a speci-
fied number. Yes No
407 (0197) Measurement condition set
(3000-series) Sets measurement conditions. Yes No
408 (0198) Measurement condition release
(3000-series) Releases measurement conditions that
have been set. Yes No
409 (0199) Measurement condition list
request (3000-series) Requests the measurement conditions
that have been set and other settings. No Yes
410 (019A) Single run measurement start
(3000-series) When the sample measurement condi-
tion is from 1 to 999, performs a single
run measurement and requests the mea-
surement results. No Yes
411 (019B) Zero run measurement start
(3000-series) If the sample measurement condition is
zero, starts a zero run measurement. No No
412 (019C) Continuous measurement start
(scan) (3000-series) Starts a continuous measurement. The
scan notification method is used for
receive data. No Yes
413 (019D) Continuous measurement start
(interrupt (*2)) (3000-series) Starts a continuous measurement. The
interrupt notification method is used for
receive data. No Yes
414 (019E) Measurement termination
(3000-series) Terminates a continuous measurement. No No (*1)
415 (019F) Data request (3000-series) Requests display data in the idle mea-
surement status or the latch data gener-
ated by the measurement command. No Yes
416 (01A0) Statistic processing execution
(3000-series) Lights the statistic processing LED and
processes the statistics. No No
417 (01A1) Statistic processing non-execu-
tion (3000-series) Turns OFF the statistic processing LED.
Statistics are not processed. No No
418 (01A2) All statistic memory clear
(3000-series) Clears statistic processing memories of
all programs. No No
419 (01A3) Statistic memory clear
(3000-series) Clears statistic processing memories of
program under display. No No
420 (01A4) Statistic result request
(3000-series) Requests statistic processing result. No Yes
421 (01A5) Memory switch set 1
(3000-series) Sets memory switches. Yes No