Omron CJ1W-FLN22, Руководство по эксплуатации, Страница: 76 / 277

CPU Bus Unit System Setup Section 4-2
50
4-2-1 System Setting - CPU Bus Unit Setup Area
Note
Refer to SECTION 11 CX-FLnet Support Software Operations for CX-FLnet
procedures.
Item Content
FA Link mapping table method
(default: PLC build-in method)
Selects the method (PLC build-in method or FA Link Unit build-in method) for storing
the FA Link mapping table.
Normally the default should be selected.
FA Link startup method
(default: Auto-participating)
Selects the method (auto-participating or manual-participating) for starting the FA
Link.
Normally the default should be selected.
Confirm message protocol
(default: Confirmed)
Selects the protocol (confirmed or unconfirmed) for when messages are used.
Select Confirmed for a network with OMRON FL-net Units only.
Select Unconfirmed for a network in which units from other manufacturers are con-
nected.
Broadcast type
(default: ***.***.***.255)
Selects the broadcast type (***.***.***.255 or C255.255.255.255).
Normally the default should be selected.
IP address set method
(default: 192.168.250 + Node No.)
Selects the IP address setting method ( 192.168.250 + Node No. , Unit rear rotary SW ,
Unit rear rotary SW + Node No., or Setup Area ).
Normally the default should be selected.
When using CS1W-FLN22 or CJ1W-FLN22, select either 192.168.250 +Node No or
Setup Area.
Sub-net mask
(default: 255.255.255.0)
Sets the sub-net mask (user setting).
Normally the default should be selected.
IP address
(default: None)
Sets the IP address (user setting). The IP address does not need to be set except
when the
IP address set method is se to Setup Area .
No. of the other nodes in FA Link
(default: None)
The number of remote nodes (user setting) in the FA Link configuration is displayed.
This parameter cannot be set.
Baud Rate Setting
(default: 10 Mbps (not variable))
Sets the baud rate for FL-net communications. To communicate at 100 Mbps, select
Auto .
The baud rate is determined by the auto-negotiation function of the connected hub.