Omron CJ1W-FLN22, Руководство по эксплуатации, Страница: 207 / 277

181
Operating Procedures Section 11-2
11-2-8 Unit Area Setup
The Unit's data display and node name can be set.
Note Select Option - Switch display - Hex . It will be possible to display and input
in hexadecimal.
11-2-9 Monitor Status Display Function
The CX-FLnet enables monitoring of various network conditions and settings.
■
Selecting the Status Display Function
Select the status from among those displayed in the Status Menu in the Main
Menu.
Menu Function
Allowed min. frame interval
(default: 1 (100 us))
Sets the present minimum allowable frame interval. Valid must be selected to enable
this setting. If communications errors occur, increase the value of this setting. The
maximum allowable frame interval used for the entire network is that of the node with
the longest minimum allowable frame interval. The present valid value for the net-
work can be checked by selecting
Network status (FA Link) in the Monitor Field.
When a baud rate of 100 Mbps is used, set the minimum allowable frame interval to
1 ms or higher.
Token watchdog timer
(default: 50 ms)
Sets the timeout time for monitoring token passing between nodes. For normal
usage, use the default value.
Wait time of min. frame interval
(default: 0)
Adds the value set here to the minimum allowable frame interval set in (1). This value
is not used by the entire network. This value is only enabled for the corresponding
node.
Node name Sets the node name. Valid must be selected to enable this setting.