Omron CJ1W-FLN22, Руководство по эксплуатации, Страница: 205 / 277

179
Operating Procedures Section 11-2
Note Select Option - Switch display - Hex . It will be possible to display and input
words, sizes, and addresses in hexadecimal.
11-2-6 System Setting - Other Node Setup Area
The other node setup areas are be set so that Common Memory data for
remote nodes can be read to the local PLC areas.
The following functions can be used when setting the other node setup areas.
Item Content
Area 1 (Area 2) Memory Area
(default: Area 1 CIO, Area 2 DM)
Sets the PLC area in which Cyclic Data Areas 1 and 2 for the local node are stored.
The following areas can be set: CIO, WR, HR, DM, and EM0 to EMC.
Area 1 (Area 2) start word
(default: 0)
Sets the beginning word of the PLC area in which Cyclic Data Areas 1 and 2 for the
local node are stored.
Area 1 (Area 2) size
(default: 0)
Sets the size of the PLC area in which Cyclic Data Areas 1 and 2 for the local node
are stored. This setting also determines the size allocated to this node for Common
Memory.
Area 1 (Area 2) Start address of
Common Memory
(default: 0)
Sets the beginning address of the Common Memory allocated to Area 1 (or Area 2).
Item Content
Area 1 (Area 2) Memory Area
(default: Area 1 CIO, Area 2 DM)
Sets the PLC area in which Cyclic Data Areas 1 and 2 for the remote nodes are
stored.
The following areas can be set: CIO, WR, HR, DM, and EM0 to EMC.
Area 1 (Area 2) start word
(default: 0)
Sets the beginning word of the PLC area in which Cyclic Data Areas 1 and 2 for the
remote nodes are stored.
Mapping area table Sets the offset, size and mapped node numbers of the PLC area in which Cyclic Data
Areas 1 and 2 for the remote nodes are stored.
Menu Function
Edit - Clear all Clear all data in the FA link table.