Omron CJ1W-FLN22, Руководство по эксплуатации, Страница: 204 / 277

Operating Procedures Section 11-2
178
Note 1. To circulate a token among the nodes connected to the network, match the
uppermost three digits of the IP address, the sub-net mask, and the broad-
cast type to those of the other connected nodes.
2. If either Unit rear rotary SW + node No . or Unit rear rotary SW is set as the
IP address setting method for the CS1W-FLN22 or CJ1W-FLN22, a setting
error will occur (HER indicator will light). Set the IP address setting method
to either
192.168.250 + node No . (default) or Setup Area .
3. The baud rate setting is supported by the CS1W-FLN22 and CJ1W-FLN22
only. The setting cannot be made for the CS1W-FLN02 or CS1W-FLN12,
which always communicate at 10 Mbps.
4. Select Option - Switch display - Hex in the Main Window. It will be pos-
sible to display and input the IP address and sub-net mask in hexadecimal.
5. If the communications are set to connect via the network and storage in the
PLC is set to use the FA link allocation table storage method, the maximum
number of nodes that can be registered in other node areas is 50.
11-2-5 System Setting - Local Node Setup Area
The local node setup area can be set so that data from any PLC area can be
used as the send data from the local node.
IP address
(default: None)
Sets the IP address (user setting).
The IP address does not need to be set except when the IP address set method is set
to
Setup Area.
No. of the other nodes in FA Link
(default: None)
The number of remote nodes (user setting) in the FA Link configuration is displayed.
This parameter cannot be set.
Baud Rate Setting
(default: 10 Mbps (not variable))
Sets the baud rate for FL-net communications. To communicate at 100 Mbps, select
Auto . The baud rate will be determined by the auto-negotiation function of the con-
nected hub.
Item Content