![background image](http://html1.mh-extra.com/html/omron/c200hw-cort21-v1/c200hw-cort21-v1_operation-manual_742282051.webp)
Physical layout of the Unit
Section 3-1
34
BR2
BR1
BR0
Baud rate (kbit/s)
OFF
OFF
OFF
10
OFF
OFF
ON
20
OFF
ON
OFF
50
OFF
ON
ON
125
ON
OFF
OFF
250
ON
OFF
ON
500
ON
ON
OFF
800
ON
ON
ON
1000
Note
The C200HW-CORT21-V1 allows configuration of any arbitrary baud rate
supported by CAN via the Unit settings (DM settings). Refer to appendix D
for the definition of these Unit settings.
3-1-5 BUS Connector
The CAN bus connector is a 5-pin male open style connector. Its pins are
numbered 1 to 5 starting from the top. The label next to the connector
indicates the colour of the individual wire in the cable that has to be
connected to the respective pin.
The CAN interface of C200HW-CORT21-V1 requires external power supply
for the transceiver and opto-couplers. Therefore 24V DC
±
10% must be
connected between pin 1 and 5. The current consumption Is less than 45
mA.
Pin No.
Signal
Description
1
CAN_V+
External power supply for the CAN interface (24V DC).
2
CAN_H
Data signal (dominant high)
3
CAN_SHLD
Optional CAN shield
4
CAN_L
Data signal (dominant low)
5
CAN_GND
Ground (0V of external power supply)
Содержание C200HW-CORT21-V1
