Omron BU100RS, Инструкция по эксплуатации

Страница: 48 / 102

3 Check and start operation
3-3 Start and stop procedures and basic operation
BU100RS
47
3
3-3 Start and stop procedures and basic operation
3-3-1 Start and stop procedures
For cautions when operating the UPS, including start and stop, refer to “Caution (for use)”
shown in the “Safety precautions” of the beginning of this manual.
■
Start procedure
Turn on the “Power” switch of the UPS.
・ Output begins in Inverter Operation a few seconds after the switch is activated.
(Status indicator “ “)
・ The status indicator displays “ “, and the self-diagnostic test is performed in
Battery Mode for about 10 seconds. (If the battery voltage is low, the
self-diagnostic test is not performed. It is automatically executed after the battery
is charged.) When the self-diagnostic test finishes successfully, switching to AC
output from commercial power is performed and normal operation starts.
・ When the self-diagnosis test finishes normally, the unit enters the normal
operating state through inverter operation.
・ When the self-diagnostic test is not performed, AC output begins immediately
inverter operation.
・ During operation, the battery is charged automatically.
AC input
Status indicator
Power supply SW
Power supply
output LED
Operating mode
Output
ON
OFF
ON
OFF
ON
OFF
Commercial
Power Battery
Commercial
Power Battery
<Note>
D-1: Display the latest UPS fault mode
(If there is no record for UPS fault, UPS display the
Startup
preparation
a few
seconds
Bypass
operation
a few
seconds
Self-diagnostic
test
about
15 sec.
Inverter
operation
D-1
1 sec.
Status indicator
Beep None
Power supply output receptacles Outputs power (connected devices are powered)