Omnitronic RS-1222, Руководство пользователя

Страница: 25 / 31

10040100_V_1_1.DOC 25/31
Main Mix fader
With the Main Mix fader, you can adjust the output signal of the MAIN OUT-sockets.
5.4 Power-section
AC INPUT
Typ/Type:
Spannungsversorgung:
Power supply:
Gesamtanschlusswert
(max.):
Power consumption
(max.):
OMNITRONIC SHOWEQUIPMENT GmbH, GERMANY
OMNITRONIC RS-1622
2 x 20 V AC,
50/60 Hz
25 W
~
POWER
AC INPUT SOCKET
Used to plug the power unit in.
POWER SWITCH
Press this button to start operation.
6. OPERATION
6.1 Adjusting the input level
Every input channel should be adjusted to the same level, so that an even sound can be reached.
Connect your headphones to the Headphones-socket or your speaker-system to the CTRL R OUT-sockets.
Turn the HEADPHONES/CONTROL ROOM LEVEL-control to the center position.
Press the G1-2/PFL-switch.
Press the L-R/G1-2-switch.
Follow this procedure for every input channel:
1. Turn the Gain-control to minimum.
2. Turn the Equalizer-control to center position.
3. Turn the Aux-control to minimum.
4. Turn the Pan/Bal-control to center position.
5. Press the PFL-switch.
6. Make sure that the L-R-switch is not pressed.
7. Make sure that the G1-2-switch is not pressed.
8. Move the channel fader to minimum.
9. Apply a typical audio-signal to this channel. The -20 dB LED should flash. Turn the Gain-control to the
right until the LED-meter flashes at 0 dB. If the PEAK-LED of the input channel flashes, the input signal
is distorted. Turn the Gain-control to the left in order to reduce the input level.
If you want to adjust the equalizers of this channel, adjust the controls as desired and repeat step 5.
10. Press the PFL-switch so that it is not unpressed.
11. Carry out steps 1-6 for every input channel.
6.2 Routing
Every input channel can be routed to different busses. If you want to add the different mics of a drumset to a
group, press the G1-2-switch of the respective input channel. You can adjust the group signal via the group
fader. When you press the G1-2 to L-R-switch, you can route the group signal to the Main Mix fader.
If you want to route an input signal directly to the Main Mix fader, press the L-R-switch of the respective
channel.