80-J7616-1 Rev. C
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
16
4)
TT150
Installation Planning
Important Notes
Refer to Chapter 3: General Wiring Guidelines, while planning your installation. The cable
chapter provides specific information on cables and wiring and should be considered during
the installation planning stage.
Installers should be familiar with basic automotive wiring.
Regulatory Compliance Information
FCC/IC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Caution
The TT150 is not certified as being intrinsically safe (IS). Do not install or operate in areas
where IS certified devices are required.
This equipment should be installed and operated with minimum 20 cm between the
radiator and body. This transmitter must not be collocated or operating in conjunction with
any other antenna or transmitter unless authorized to do so by the FCC/IC.
General Installation Information
Verify the Trailer Is in Good Condition
Before beginning an installation:
•
Thoroughly evaluate the area
prior
to installation to ensure the area where the
installation will take place is in good condition. Determine if the TT150 system can be
installed on the trailer.
•
Verify there is no obvious or extreme damage to the trailer nose at the TT150 system
installation area.
•
The trailer top rail above the 7-way should be flat and free of bends or deep dents.
•
The 7-way connection points should be inspected for general cleanliness and corrosion.
•
Verify that there is voltage on pin 7 and at all 7-way connection points when external
power is applied.
