Omnitracs MCP100, Руководство по установке

Страница: 80 / 256

Installing the MDU Cable Media Display Unit (MDU) Installation
9-4
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
80-J4866-2 Rev. G
6. Pass the 10-32 machine screws through the holster and mounting holes and tighten
until snug.
Installing the MDU Cable
• Connects MDU to MAS.
MDU Cable Run
• Run direction — In most vehicles, the display unit is mounted in the dash area. Route the
cable from the MDU to the MAS with the coiled end of the cable at the MDU and the
uncoiled end routed to the MAS. If drilling is necessary, the 9-pin DSUB connector end of
the display cable requires a 1-1/2" hole.
• Routing location — Route the cable internally or externally.
- In a few vehicles, the display unit may be installed in the sleeper. In this case, route the
cable internally to this area.
• Cable dressing — For strain relief, the base of the coil should be secured with tie wraps.
The strain-relief tie wrap is normally positioned at the point where the cable transitions
from a straight cable to a coiled cable.
Connecting the MDU Cable to the MDU
1. If the cable is not yet routed, refer to page 3-11 for routing procedures.
Caution
Do not step on or drop any objects on the display cable connectors. Do not let the
connectors lie on the ground unprotected.
2. Use a #10 Torx driver to remove the MDU’s back housing.
3. Remove the protective cap on the connector.
• Inspect the connectors for damage and bent pins.
4. Plug in connector.
Esc
#
4
$
5
%
6
^
7
&
8
*
9
(
0
)
=
Backspace
+
Tab
0
E
R
T
Y
U
I
P
{
[
{
[
Enter
Delete
Shift
L
K
J
H
G
F
D
"
'
M
N
B
V
C
V
V
?
!!
Opt
Back
1
! !
2
@
3
Q
Caps
W
Shift
Ctrl
Alt
Sym
S
A
X
Z
Mounting Surface
MDU
Holster